PAD symbol "M" has an undefined IOSTANDARD. PAD symbol "M" is not constrained (LOC) to a specific location. All of the single ended outputs in this design are using slew rate limited output drivers. The delay on speed critical single ended outputs can be dramatically reduced by designating them as fast outputs. Initializing temperature to 85.000 Celsius. (default - Range: 0.000 to 85.000 Celsius) Initializing voltage to 0.950 Volts. (default - Range: 0.950 to 1.050 Volts) The Interim Design Summary has been generated in the MAP Report (.mrp). Map created a placed design. The IOB D is either not constrained (LOC) to a specific location and/or has an undefined I/O Standard (IOSTANDARD). This condition may seriously affect the device and will be an error in bitstream creation. It should be corrected by properly specifying the pin location and I/O Standard. The IOB K is either not constrained (LOC) to a specific location and/or has an undefined I/O Standard (IOSTANDARD). This condition may seriously affect the device and will be an error in bitstream creation. It should be corrected by properly specifying the pin location and I/O Standard. The IOB M is either not constrained (LOC) to a specific location and/or has an undefined I/O Standard (IOSTANDARD). This condition may seriously affect the device and will be an error in bitstream creation. It should be corrected by properly specifying the pin location and I/O Standard. The IOB S is either not constrained (LOC) to a specific location and/or has an undefined I/O Standard (IOSTANDARD). This condition may seriously affect the device and will be an error in bitstream creation. It should be corrected by properly specifying the pin location and I/O Standard. The IOB V is either not constrained (LOC) to a specific location and/or has an undefined I/O Standard (IOSTANDARD). This condition may seriously affect the device and will be an error in bitstream creation. It should be corrected by properly specifying the pin location and I/O Standard.